The beams weighed about 500 kilos each, but all the lifting was done by 4 manpower, jacks, comalongs rope and peel ply.
-Peel ply?
-Yes, it is surprisingly strong and stretched less than the rope
Although a tight fit it was easy enough to slide the beams into the lee hull.
Th difficult part was slipping the beams into the slots of the windward hull. Doing it the other way round was not an option due to the amount of reinforcing around the lee hull beam slot and UHMWPE mast bearings which were already installed.
We got the further beam slotting in easily enough, but know amount of pulling with cum-alongs and altering the 'horizontality' of the hulls would get the closer beam to go all the way. Eventually we had to cut out the bit of the ww hull above the beam slot, shave things a bit, and slide then slide the beams in all the way.
This gave us the opportunity to really glue the near beam to the hull. Pic was taken before reinstalling the hull piece over the beam
-Peel ply?
-Yes, it is surprisingly strong and stretched less than the rope
Although a tight fit it was easy enough to slide the beams into the lee hull.
Th difficult part was slipping the beams into the slots of the windward hull. Doing it the other way round was not an option due to the amount of reinforcing around the lee hull beam slot and UHMWPE mast bearings which were already installed.
We got the further beam slotting in easily enough, but know amount of pulling with cum-alongs and altering the 'horizontality' of the hulls would get the closer beam to go all the way. Eventually we had to cut out the bit of the ww hull above the beam slot, shave things a bit, and slide then slide the beams in all the way.
This gave us the opportunity to really glue the near beam to the hull. Pic was taken before reinstalling the hull piece over the beam
